Home / Optics / Aimpoint COA / Moving it between pistols

Moving the Aimpoint COA between pistols

Page last updated . Data compiled September 2026 by Andrew Terrebonne.

You already own it. Here is what changes from one slide to the next: the plate, the screw thread at each joint, the torque, the tools and any thread trap. 2 kinds of slide, covering 9 pistols, grouped by how the optic mounts and then alphabetically. Nothing is ranked. The Aimpoint COA page has its specs and the per-pair answers.

1 of the 2 blocks have a figure marked not on file: no maker publishes it where this site could find it, so the plate maker or a gunsmith is the source. How the data is checked.

Mounts straight to the slide

Aimpoint A-Cut

Direct Direct mount

7 slides: GLOCK 17 / 19 / 45 Gen6 A-Cut, Springfield Armory Echelon 4.0C COA, Springfield Armory Echelon 4.0FC COA, Springfield Armory Echelon 4.5F COA, Springfield Armory 1911 DS Prodigy 4.25in COA, Springfield Armory 1911 Operator .45 COA, Springfield Armory 1911 TRP .45 COA

Optic → slide
2 rear screws + front tongueSupplied with the optic.
Optic torque
per Aimpoint manual
Tools
Torque wrench, Driver bits, Calipers, Degreaser, Witness-mark paint or lacquer
To mount
$650–900approximate street prices, September 2026

Mounts on a plate

CZ Shadow 2 OR plate system

Plate Adapter plate required

2 slides: CZ Shadow 2 Optics Ready, CZ Shadow 2 Compact Optics Ready

Plate
Shadow 2 OR → Aimpoint A-CutEemann Tech
Plate → slide
per plate maker, not on file hereSupplied with the plate.
Optic → plate
per plate maker, not on file hereSupplied with the plate, not the optic.
Plate torque
per plate instructions
Optic torque
per plate maker, not on file here
Tools
Torque wrench, Driver bits, Calipers, Degreaser, A parts tray, Witness-mark paint or lacquer
To mount
$710–995approximate street prices, September 2026

Steps and safety: installing a red dot, from the makers' manuals. Mounting an optic is gunsmithing; confirm the pistol is unloaded first. Screw length is never listed here because it depends on the whole stack: each pair's build sheet has a calculator that works from your own caliper readings.

Something on this page wrong? Tell us what it should be, and include a source: nothing changes without one.