Moving the Holosun SCS 320 between pistols
Page last updated . Data compiled September 2026 by Andrew Terrebonne.
You already own it. Here is what changes from one slide to the next: the plate, the screw thread at each joint, the torque, the tools and any thread trap. 3 kinds of slide, covering 12 pistols, grouped by how the optic mounts and then alphabetically. Nothing is ranked. The Holosun SCS 320 page has its specs and the per-pair answers.
2 of the 3 blocks have a figure marked not on file: no maker publishes it where this site could find it, so the plate maker or a gunsmith is the source. How the data is checked.
Mounts straight to the slide
SIG P320 optic cut (Romeo1Pro pattern)
Direct Direct mount
7 slides: SIG Sauer P320 X-Carry, SIG Sauer P320 XCompact, SIG Sauer P320 XFive Legion, SIG Sauer P320 XTen, SIG Sauer P320 AXG Legion / AXG Pro, SIG Sauer P320 Spectre Comp, SIG Sauer P320-M17 / M18
- Optic → slide
- M4 × 0.7Check the optic's box for M4 screws; buy a set if it has none.
- Optic torque
- per Holosun manual
- Tools
- Torque wrench, Driver bits, Calipers, Degreaser, Witness-mark paint or lacquer
- To mount
- $300–450approximate street prices, September 2026
Mounts on a plate
CZ P-10 OR plate system
Plate Adapter plate required
3 slides: CZ P-10 C Optics Ready, CZ P-10 F Optics Ready, CZ P-10 S Optics Ready
- Plate
- P-10 OR → DeltaPoint ProCZ factory
- Plate → slide
- per plate maker, not on file hereSupplied with the plate.
- Optic → plate
- per plate maker, not on file hereSupplied with the plate, not the optic.
- Plate torque
- 1.3 Nm (11.5 in-lb)
- Optic torque
- per plate maker, not on file here
- Tools
- Torque wrench, Driver bits, Calipers, Degreaser, A parts tray, Witness-mark paint or lacquer
- To mount
- $360–545approximate street prices, September 2026
CZ Shadow 2 OR plate system
Plate Adapter plate required
2 slides: CZ Shadow 2 Optics Ready, CZ Shadow 2 Compact Optics Ready
- Plate
- Shadow 2 OR → DeltaPoint ProCZ factory
- Plate → slide
- per plate maker, not on file hereSupplied with the plate.
- Optic → plate
- per plate maker, not on file hereSupplied with the plate, not the optic.
- Plate torque
- per plate instructions
- Optic torque
- per plate maker, not on file here
- Tools
- Torque wrench, Driver bits, Calipers, Degreaser, A parts tray, Witness-mark paint or lacquer
- To mount
- $360–545approximate street prices, September 2026
Steps and safety: installing a red dot, from the makers' manuals. Mounting an optic is gunsmithing; confirm the pistol is unloaded first. Screw length is never listed here because it depends on the whole stack: each pair's build sheet has a calculator that works from your own caliper readings.